LEGRAND Raritan PX3TS, User Manual

Page: 72 / 911

Chapter 4: Connecting External Equipment (Optional)
52
4. If intended, connect one DPX sensor package to the OUT port of the
differential air pressure sensor. It can be any DPX sensor package, such as a
DPX-T3H1.
The PX3TS
Raritan differential air pressure sensors
One DPX sensor package (optional)
RJ-12 to RJ-45 adapter
Using an Optional DPX-ENVHUB4 Sensor Hub
Optionally, you can connect a Raritan DPX-ENVHUB4 sensor hub to the PX3TS.
This allows you to connect up to four DPX sensor packages to the PX3TS via the
hub.
This sensor hub supports DPX sensor packages only. Do NOT connect DPX2,
DPX3, DX or DX2 sensor packages to it.
DPX-ENVHUB4 sensor hubs CANNOT be cascaded. You can connect only one
hub to each SENSOR port on the PX3TS.
Tip: The Raritan sensor hub that supports ALL types of Raritan environmental
sensor packages is
DPX3-ENVHUB4 . See Using an Optional DPX3-ENVHUB4
Sensor Hub (on page 56).
To connect DPX sensor packages via the DPX-ENVHUB4 hub:
1. Connect the DPX-ENVHUB4 sensor hub to the PX3TS.
a. Plug one end of the Raritan-provided phone cable (4-wire, 6-pin, RJ-12)
into the IN port (Port 1) of the hub.
b. Get an RJ-12 to RJ-45 adapter. Connect this adapter's RJ-12 connector
to the other end of the phone cable.