LEGRAND Raritan PX3TS, User Manual

Page: 552 / 911

Chapter 9: Using the Command Line Interface
532
Network Configuration
This command shows all network configuration and all network interfaces'
information, such as the IP address, MAC address, the Ethernet interfaces'
duplex mode, and the wireless interface's status/settings.
# show network
IP Configuration
This command shows the IP settings shared by all network interfaces, such as
DNS and routes. Information shown will include both IPv4 and IPv6
configuration.
Tip: To show IPv4-only and IPv6-only configuration data, see IPv4-Only or
IPv6-Only Configuration (on page 533).
# show network ip common
To show the IP settings of a specific network interface, use the following
command.
# show network ip interface <ETH>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2 , WIRELESS , or BRIDGE .
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface Description
eth1 Show the IP-related configuration of the ETH1
interface.
eth2 Show the IP-related configuration of the ETH2
interface.
wireless Show the IP-related configuration of the WIRELESS
interface.
bridge Show the IP-related configuration of the BRIDGE
interface.