Chapter 6: Using the Web Interface
496
Configure the door handles connected to DX2-DH2C2. You must set
this because PX3 cannot detect the types of connected door handles.
Control the door handles connected to DX2-DH2C2.
To configure the door handles:
There are two door handle sections per DX2-DH2C2 because a
DX2-DH2C2 has two door handle ports. Before you configure the
connected door handle(s), a lock icon is displayed on each door handle
section's top-right corner, and both the Door State and Card Reader
sections are unavailable.
1.
Click Edit Settings in the Settings section.
2.
In the 'Door handle type' field, select the door handle type you are
using.
If your specific Southco H3-EM model is listed, select it. For all
other supported Southco H3-EM models, select "Southco
H3-EM".
Restriction: A few door handles require a minimum firmware version
to support them. For example, firmware version older than 3.5.10 do
NOT support Dirak door handles.
3.
Make changes to the remaining fields as needed.
Summary of Contents for Raritan PX3-3000 Series
