LEGRAND Raritan PX3-3000 Series, User Manual

Page: 44 / 977

Chapter 3: Initial Installation and Configuration
23

Plug a supported USB wireless LAN adapter into the USB-A port
on your PX3.

Connect a USB hub to the USB-A port on the PX3. Then plug the
supported USB wireless LAN adapter into the appropriate USB
port on the hub.
See USB Wireless LAN Adapters (on page 23) for a list of supported
wireless LAN adapters.
USB Wireless LAN Adapters
The PX3 supports the following USB Wi-Fi LAN adapters.
Wi-Fi LAN adapters Supported 802.11
protocols
SparkLAN WUBR-508N A/B/G/N
Proxim Orinoco 8494 A/B/G
Zyxel NWD271N B/G
Edimax EW-7722UnD A/B/G/N
TP-Link TL-WDN3200 v1 A/B/G/N
Raritan USB WIFI A/B/G/N
Supported Wireless LAN Configuration
If wireless networking is preferred, ensure that the wireless LAN
configuration of your PX3 matches the access point. The following is the
wireless LAN configuration that the PX3 supports.

Network type: 802.11 A/B/G/N

Protocol: WPA2 (RSN)

Key management: WPA-PSK, or WPA-EAP with PEAP and
MSCHAPv2 authentication

Encryption: CCMP (AES)
Tip: Supported 802.11 network protocols vary according to the
wireless LAN adapter being used with the PX3. See
USB Wireless
LAN Adapters (on page 23).
Note: You must configure PX3 to enable its wireless LAN interface.
See the topic titled
Configuring Network Settings (on page 286) in the
User Guide.