LEGRAND Raritan PX3-3000 Series, User Manual

Page: 728 / 977

Chapter 8: Using the Command Line Interface
707
Restarting the PDU
This command restarts the PX3. It is not a factory default reset.
To restart the PX3:
1. Ensure you have entered administrator mode and the # prompt is
displayed.
2. Type either of the following commands to restart the PX3.
# reset unit
-- OR --
# reset unit /y
3. If you entered the command without "
/y
" in Step 2, a message
appears prompting you to confirm the operation. Type y to confirm
the reset.
4. Wait until the reset is complete.
Note: Device reset will cause CLI communications over an "USB"
connection to be lost. Therefore, re-connect the USB cable after the
reset is complete.
Resetting Active Energy Readings
You can reset either one active energy sensor or all active energy
sensors at a time to restart the energy accumulation process.
Only users with the "Admin" role assigned can reset active energy
readings.
To reset all active energy readings of the PX3:
# reset activeEnergy pdu
-- OR --
# reset activeEnergy pdu /y
To reset one inlet's active energy readings:
# reset activeEnergy inlet <n>
-- OR --
# reset activeEnergy inlet <n> /y
To reset one outlet's active energy readings:
# reset activeEnergy outlet <outlet_n>
-- OR --