LEGRAND Raritan PX3-3000 Series, User Manual

Page: 911 / 977

Appendix L: Additional PX3 Information
890
Pin signal DB9 pin No. RJ-45 pin No.
CTS 8 8
RIR 9 N/A
Note: The RJ45-to-DB9 adapter/cable used for connecting modems
CANNOT be used to connect the PX3 to a computer. See
RJ45-to-DB9
Cable Requirements for Computer Connections
(on page 32).
Reserving IP Addresses in DHCP Servers
PX3 uses its serial number as the client identifier in the DHCP request.
Therefore, to successfully reserve an IP address for the PX3 in a DHCP
server, use the PX3 device's serial number as the unique ID instead of
the MAC address.
Since all network interfaces of the PX3 can be simultaneously enabled
and configured with diverse static IP addresses, the client identifier of
each network interface is different. The main difference is the
absence/presence of a suffix, which is the interface name added to the
end of the serial number. The table below lists the client identifiers of all
network interfaces.
Interface Client identifier
ETH1 serial number
ETH2 serial number plus the uppercase suffix "-ETH2"
WIRELESS serial number plus the uppercase suffix "-WIRELESS"
BRIDGE serial number
You can reserve the IP addresses of more than one interfaces in the
DHCP server if preferred. Note that you must choose/configure the
bridge interface if your PX3 is set to the bridging mode.
Important: In the bridging mode, only the IP parameters of the
BRIDGE interface function. The IP parameters of ETH1/ETH2 and
WIRELESS interfaces do NOT function.