LEGRAND Raritan PX3-3000 Series, User Manual

Page: 845 / 977

Appendix H: Old Generations of PX3 Models
824
To display the unbalanced load and active power of a 3-phase
inlet:
1. Switch to the current reading of any inlet line.
2. Press the Up or Down button until "W" or "%" is displayed to the
right of the LCD display. Make sure NONE of the inlet's line number
is displayed at the bottom of the display.

Unbalanced load - % is displayed for the unbalanced current
value.

Active power - W is displayed for the power reading. W means
Watt.
Overcurrent Protector Information
The Overcurrent Protector mode is displayed as either "CB" or "FUSE"
on the LCD display, which varies according to the type of overcurrent
protector implemented on your PX3. CB refers to the circuit breaker and
FUSE refers to the fuse.
Below illustrates an overcurrent protector's information.
Section Example information
The selected target is the second circuit breaker (CB 2).
This circuit breaker's current reading is 0 amps.
The word "CLOSE" indicates that the state of the selected
circuit breaker is closed.
"MASTER" indicates the PX3 is the master device in a
cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: "MASTER/SLAVE" information is only available in
Port Forwarding mode.
The measurement unit is A (Amp), indicating that the
reading is the current.