LEGRAND Raritan PX3-3000 Series, User Manual

Page: 841 / 977

Appendix H: Old Generations of PX3 Models
820
Section Information shown
The selected mode and target, such as INLET 1, OUTLET
1, SENSOR 1, SENSOR 2, and so on.
The following information is displayed:

Readings, data or state of the selected target.

During the firmware upgrade, "FUP" is displayed.
Two types of information may be displayed:

The "ALARM" status of the selected target.

The selected inlet line number if your PX3 is a
3-phase model.
The measurement unit of the displayed data, such as %
or
.
This section indicates:

The Asset Strip mode if an asset strip has been
connected to the PX3.

The device's USB-cascading state -
MASTER or
SLAVE. If it is a standalone device, neither MASTER
nor SLAVE is displayed.
Note: During the firmware upgrade, some PX3 models may show b
x
in
the section 1 to indicate the relay or meter board numbered
x
is being
updated.
Control Buttons
There are four control buttons.

Up and Down buttons for selecting a specific target, which can be an
inlet, outlet, overcurrent protector, environmental sensor or a device
setting

MODE button for switching between various modes, including:
- Inlet mode
- Outlet mode
- Overcurrent Protector mode
- Device mode
- Sensor mode