Ceyear 4051 Series, User Manual

Page: 623 / 751

5 Menu
5.2. Description of menu
609
[Best for Dynamic Range]
● Menu description: to set the RF Gain distribution algorithm to Best Dynamic Range. In this case, the RF
Gain is switched to ―Auto OFF‖
●
Key path: 【 Meas Setup 】 , [More 1/3], [More 2/3], [RF Gain ▶ ], [Best for Dynamic Range] on the front
panel.
●
Status saved: saved in the instrument status.
[Best for Sensitivity]
●
Menu description: to set the RF Gain distribution algorithm to Best Sensitivity. In this case, the RF Gain
is switched to ―Auto OFF‖
● Key path:
【
Meas Setup
】
, [More 1/3], [More 2/3], [RF Gain
▶
], [Best for Sensitivity] on the front panel.
● Status saved: saved in the instrument status.
[ADC Dither Auto Man]
● Menu description: to control opening/closing of ADC dither of the frequency acquisition circuit in the
analyzer. Under default mode, the signal/spectrum analyzer will automatically control whether the ADC
Dither is ON based on current working condition. When the ADC Dither is under Auto mode, the ON or
OFF status depends on the span, resolution bandwidth and sweep type (continuous swept or step sweep);
when it is continuous swept, the ADC Dither status will force to switch to Auto and turns off; when it is
step sweep, under Auto mode, if the span is 2MHz or below, the ADC Dither is ON; if the span is below
2MHz, the ADC Dither is OFF. Under Auto OFF mode, if the span is above 2MHz, turning on the ADC
Dither may affect the measurement results based on selected dither status. You can access the submenu
for manual control.
● Key path:
【
Meas Setup
】
, [More 1/3], [More 2/3 ], [ADC Dither Auto Man] on the front panel.
● Status saved: saved in the instrument status.
● Factory preset: Auto.
● Remote Command:
[:SENSe]:SEMask:ADC:DITHer[:STATe] OFF|ON|HIGH
[:SENSe]:SEMask:ADC:DITHer[:STATe]?\n
[:SENSe]:SEMask:ADC:DITHer:AUTO[:STATe] OFF|ON|0|1
[:SENSe]:SEMask:ADC:DITHer:AUTO[:STATe]?
[Meas Preset]
• Menu description: to reset the measurement parameters to the factory preset status or user saved parameter
status
•Key path: 【 Meas Setup 】 , [More 1/3], [More 2/3 ], [Meas Preset] on the front panel.
• Factory preset: factory reset.
•Remote Command:
:CONFigure:SEMask
5.2.11.18 Measurement Control