Ceyear 4051 Series, User Manual

Page: 564 / 751

5 Menu
5.2. Description of menu
550
● Status saved: saved in the instrument status.
● Factory preset: Auto.
● Remote Command:
[:SENSe]:HARMonics:ADC:DITHer[:STATe] OFF|ON|HIGH
[:SENSe]:HARMonics:ADC:DITHer[:STATe]?\n
[:SENSe]:HARMonics:ADC:DITHer:AUTO[:STATe] OFF|ON|0|1
[:SENSe]:HARMonics:ADC:DITHer:AUTO[:STATe]?
[Meas Preset]
● Menu description: to reset the measurement parameters to the factory preset status or user saved
parameter status
●
Key path: 【 Meas Setup 】 , [More 1/2 ▶ ], [Meas Preset] on the front panel.
●
Factory preset: factory reset.
● Remote Command:
:CONFigure:HARMonics
5.2.8.18 Measurement Control
Pop up the More related to Meas Control, including [Measure Single Cont], [Restart] and [Pause/Resume].
[Measure Continuous ON OFF]
●
Menu description: to set continuous measurement OFF or ON. When the [Measure Single Cont]is set as
Cont mode, Cont On mode will be triggered and Cont sweep will be the default measure control method;
when the [Measure Single Cont]is set as Single mode, single sweep will be triggered. Press
【
Sweep
Single
】
to restart sweep when the next trigger signal arrives.
● Key path: 【 Meas Control 】 , [Meas Single Cont On Off] on the front panel.
● Status saved: saved in the instrument status.
● Factory preset: Continuous On.
● Remote Command:
:INITiate:CONTinuous OFF|ON|0|1
:INITiate:CONTinuous?
● Examples:
:INIT:CONT OFF
[Restart]
● Menu description: to stop current measurement and restart measurement for the signal/spectrum analyzer.
● Key path:
【
Meas Control
】
, [Restart] on the front panel
● Status saved: not saved in instrument status.
● Remote Command:
:INITiate:REST