Ceyear 4051 Series, User Manual

Page: 542 / 751

5 Menu
5.2. Description of menu
528
(with 10 as base) and obtain the trace data. When the scale type is linear, those average values are trace
data.
●
Key path: 【 Trace 】 , [More 1/2 ▶ ], [Detector ▶ ], [Average ▶ ], [Voltage Avg] on the front panel.
●
Status saved: saved in the instrument status.
● Remote Command:
:TXPower:DETector SCALar
:TXPower:DETector?
5.2.7.7 Sweep
Enable sweep-related parameter setup function to pop up corresponding soft More, including [Sweep Time
Auto Man], [Sweep Setup
▶
] and [Sweep Points].
[Sweep Time Auto Man]
● Menu description: to change the sweep time of signal/spectrum analyzer. Use the number keys, step keys
or knob to adjust the sweep time. When it is under Auto OFF mode (shaded), it indicates that sweep time
can be set manually. When it is under Auto ON status, the sweep time will be automatically coupled
based on resolution bandwidth, span and video bandwidth
● Key path:
【
Sweep
】
, [Sweep Time Auto Man] on the front panel.
● Status saved: saved in the instrument status.
● Factory preset: sweep time Auto.
:TXPower:SWEep:TIME:AUTO?
● Examples:
:TXP:SWE:TIME 500 ms
:TXP:SWE:TIME:AUTO OFF
[Sweep points]
● Menu description: to set the trace points.
● Key path: 【 Sweep 】 , [Sweep Points] on the front panel.
● Status saved: saved in the instrument status.
● Factory preset: 1001.
● Setting range: 101-30001.
● Remote Command:
:TXPower:SWEep:POINts <integer>
:TXPower:SWEep:POINts?
5.2.7.8 Single
● Menu description: the
【
Single
】
key on the front panel has no corresponding soft menu. This function
is mainly used for manual trigger of a sweep. When the Average is ON, this function performs the
sweeps at the count specified by the Average Count.
In remote control programming and system establishment, this function combined with *WAI can
effectively synchronize the sweep process and enable the trace data obtained after the *WAI finishes
directly correspond to the sweep process one by one.