Omron R88D-KN01H-ECT-L, Руководство пользователя

Страница: 586 / 626

Appendices
A - 140
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Event name Interface Input Function Number Error 2 Event code 3848 0000 hex
Description
There is an undefined number specification in the input signal (IN5, IN6, IN7, and IN8) function allocations.
Or, a logic setting error was detected.
Source
EtherCAT Master Function Module
Source
details
Slave
Detection
timing
When
establishing
communications
after turning ON
power to the
slave or when
transferring
EtherCAT
Configuration
Setup
Error
attributes
Level
Minor fault
Recovery
Error reset
(after cycling slave
power)
Log category
System
Effects User program Continues. Operation Power drive circuit is OFF for relevant slave.
Indicators
EtherNet/IP NET RUN EtherNet/IP NET ERR EtherNet/IP LINK/ACT
– – –
System
-defined
variables Variable Data type Name
None – –
Cause and
correction
Assumed cause Correction Prevention
There is an undefined number
specification in the input signal
(IN5, IN6, IN7, and IN8) function
allocations. Allocate the functions to the
connector pins using only the
numbers that are defined. Allocate the functions to the
connector pins using only the
numbers that are defined.
Different logic is set for the same
function in the function
assignments of the input signals
(IN5, IN6, IN7, and IN8). Correct the settings so that the
same logic is used for the same
function. Use the same logic for the same
function.
Attached
information None
Precautions/
Remarks “33” is displayed on the Servo Drive front panel and F333 is given as the AlarmCode (4001 hex).