Omron R88D-KN01H-ECT-L, Руководство пользователя

Страница: 448 / 626

Appendices
A - 2
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
A-1 CiA402 Drive Profile
This section describes the profile that is used to control the Servo Drive.
The state of G5-series Servo Drives with built-in EtherCAT communications is called “PDS state.”
The PDS state is controlled by the Controlword (6040 hex).
The Status word (6041 hex) is displayed in each PDS state.
The state of an G5-series Servo Drive changes as shown below.
Each box indicates a state, while numbers 2 to 10 and 15 indicate the state control commands.
For details on the states, refer to State Description on page A-3. For details on command coding, refer
to Command Coding on page A-3.
Note 1 Quick stop active state is not supported. Even if a Quick stop command is received, it will be ignored.
A-1-1 Controlling the State Machine of the Servo Drive
State Machine
Start
ON
ON
ON
ON
ON ON
OFF
OFF
Shutdown: 2
7: Disable Voltage
Switch on: 3
6: Shutdown
Disable Voltage: 10
Enable operation: 4
5: Disable
operation
15: Fault reset
8: Shut down
9: Disable Voltage
13: Error occurs
Not ready to switch on
Switch on
disabled
Fault
Ready to
switch on
Switched on
Operation
enabled
Fault reaction
active
0: After the control power is turned ON
1: After initialization is completed
Control
circuit
power
supply
Main
circuit
power
supply
Servo
ON/OFF
ON or
OFF
14: Error
response
operation
completed
Power turned OFF or Reset