Omron R88D-KN01H-ECT-L, Руководство пользователя, Страница: 23 / 626

21
Safety Precautions
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Operation and Adjustment
If the Servo Drive fails, cut off the power supply to the Servo Drive.
Fire may result.
Do not block the intake or exhaust openings.
Do not allow foreign objects to enter the Servo Drive.
Fire may result.
Conduct a test operation after confirming that the equipment is not affected.
Equipment damage may result.
Check any newly set parameters and software switch settings for proper execution before
actually using them.
Not doing so may result in equipment damage.
Never adjust or set parameters to extreme values, because it will make the operation
unstable.
Injury may result.
Separate the Motor from the mechanical system and check its operation before installing
the Motor to the machine.
Injury may result.
If the magnetic body is near the Linear Motor, the cogging will occur and affect the
performance.
Malfunction or equipment damage may result.
If an error occurs, remove the cause of the error and ensure safety, and then reset the
alarm and restart the operation.
Injury may result.
Do not operate the Motor connected to an excessive load mass.
Failure may result.
Do not turn ON and OFF the main Servo Drive power supply frequently.
Failure may result.
Install equipment to prevent crash and reduce shock.
Crash against the stroke edge may occur depending on stopping distance and equipment
damage may result.
If a problem occurs in serial communications during a test operation, you have no means to
stop the Motor.
Install external hardware to ensure that the Motor can be stopped at any time.
Before transferring parameters or data from the CX-Drive and Sysmac Studio to any other
node, check the safety around the target node.
Injury may result.
Check the axis (shaft) number before operating with the CX-Drive and Sysmac Studio.
Caution