Omron R88D-KN01H-ECT-L, Руководство пользователя

Страница: 350 / 626

10 Operation
10 - 4
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
10-2 Preparing for Operation
This section explains the procedure to operate the motor and drive after installing and wiring, and also
describes items to check both before and after turning ON the power supply.
Check to be sure that the power supply voltage is within the ranges shown below.
• R88D-KN01L-ECT-L/-KN02L-ECT-L/-KN04L-ECT-L (Single-phase 100 VAC input)
• R88D-KN01H-ECT-L/-KN02H-ECT-L/-KN04H-ECT-L/-KN08H-ECT-L/-KN10H-ECT-L/
-KN15H-ECT-L (Single-phase/3-phase 200 VAC input)
• R88D-KN06F-ECT-L/-KN10F-ECT-L/-KN15F-ECT-L/-KN20F-ECT-L/-KN30F-ECT-L
(3-phase 400 VAC input)
• The main circuit power supply inputs (L1/L3 or L1/L2/L3) must be properly connected to the terminal
block.
• The control circuit power supply inputs (L1C/L2C) must be properly connected to the terminal block.
• The motor’s red (U), white (V), and blue (W) power lines and the green/yellow ( ) must be properly
connected to the terminal block.
• There should be no load on the motor. (Do not connect the mechanical system.)
• The motor side power lines and the power cables must be securely connected.
10-2-1 Items to Check Before Turning ON the Power Supply
Checking Power Supply Voltage
Main circuit power supply : Single-phase 100 to 120 VAC (85 to 132 VAC) 50/60 Hz
Control circuit power supply : Single-phase 100 to 120 VAC (85 to 132 VAC) 50/60 Hz
Main circuit power supply : Single-phase/3-phase 200 to 240 VAC (170 to 264 VAC) 50/60 Hz
Control circuit power supply : Single-phase 200 to 240 VAC (170 to 264 VAC) 50/60 Hz
Main circuit power supply : 3-phase 380 to 480 VAC (323 to 528 VAC) 50/60 Hz
Control circuit power supply : 24 VDC ± 15%
Checking Terminal Block Wiring
Checking the Motor