Omron R88D-KN01H-ECT-L, Руководство пользователя

Страница: 505 / 626

A - 59
Appendices
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
A-
1 CiA40
2 Drive Prof
ile
A
A-1
-12 Ser
v
o D
rive Pr
ofile Obje
cts
• This object sets the operation of the G5-series Servo Drive during deceleration and after stopped,
following the Ready to switch on (Shutdown) state.
Explanation of Settings
*1 “Decelerating” means that after the start of deceleration, the time during which the motor runs at 30 mm/s or
higher.
Once the motor speed reaches 30 mm/s or lower and the status changes to “After stopping”, subsequently the
operation after stopping is performed regardless of the motor speed.
*2 “Immediate Stop” means that the Linear Motor stops immediately by using controls while the servo is kept ON.
The force command value at this time is controlled by the Immediate Stop Force (3511 hex) set value.
*3 When the error is cleared, a process which makes the Position demand value follow the Position actual value
comes into effect. To operate in cyclic sync mode (csp) after the servo turns ON, reset the command
coordinates in the host controller and then execute the operation. The motor may move suddenly.
Precautions for Correct Use Precautions for Correct Use
• Position control is forced into operation during deceleration and after the motor has stopped
(main power supply OFF). The internal position command generation process is also forced to
stop.
• If an error occurs while the main power supply is OFF, operation will follow the Fault reaction
option code (605E hex).
• If the main power supply turns OFF while the Servo is ON and the Undervoltage Error
Selection (3508 hex) is set to “1”, a Main Power Supply Undervoltage (Error No. 13.1) will
occur. Operation will then follow the Fault reaction option code (605E hex). By default, the
Undervoltage Error Selection (3508 hex) is set to “1”.
605B hex
Shutdown option code
Setting
range
–5 to 0
Unit
– Default
setting
–1 Data
attribute
B
Size 2 bytes (INT16) Access RW PDO map Not possible
Set
value
Decelerating
*1
After stopping
Deceleration method Error Operation after stopping Error
–5
Immediate Stop
*2
Immediate Stop Force = 3511 hex
Clear
*3 Free
Clear
*3
–4
Immediate Stop
*2
Immediate Stop Force = 3511 hex
Clear
*3 Dynamic brake operation
Clear
*3
–3 Dynamic brake operation
Clear
*3 Free
Clear
*3
–2 Free-run
Clear
*3 Dynamic brake operation
Clear
*3
–1 Dynamic brake operation
Clear
*3
Dynamic brake operation
Clear
*3
0 Free-run
Clear
*3 Free
Clear
*3
A l l