Comdial DXP Plus Series, Руководство пользователя

Страница: 963 / 1176

DXP Programming Instructions
12.4.2
Description:
There are a total of 32 route tables that you can be program for the system. Each route table can
contain up to 6 routes. Each of these routes convey the data listed as follows:
the line group to route the call over, the access level of the route,
the modify digit table, all costing information.
Program the six routes from the least costly routing metbod to the most costly routing method.
The costliness of the route is determined by the line group over which the call is routed. ARS
will always try to select route 1 first, and then 2 through 6, when routing a call. If a station,
through its class of service assignment, does not have a route access level high enough to allow
it access the route selected by ARS, dialing is denied. If the route access level is high enough,
ARS will route the call based on the routing information If the system cannot route the call
over the line group that ARS first selects, ARS will try the next route of the route table. Once
again the route access level is tested. This process is repeated, up to a maximum of 6 times. If
the station has access to at least the first route, but is unable to dial out (because all lines are
busy), it will receive a busy tone in the handset or speaker. The station can then camp-on the
route so it will ring when a line in the route table becomes available.
Programming:
Assign line groups to routes as follows,
1 Form line groups and program them as described
On a work sheet, note the line group for each route.
2. Press CONTROL T for main menu.
3. From the main menu, select
and press ENTER.
4. From menu, select route tables and press ENTER.
5. Type l-32 to select route table to be programmed and press ENTER.
6. Type l-6 to select route and press ENTER.
7.
Type 1-16 to choose line and press ENTER.
8. Press ESCAPE and repeat steps 6-8 for all six routes.
10. Press ESCAPE twice.
11. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
12. Repeat steps 5-l 1 for all 32 tables and press ENTER.
13. Press ESCAPE twice to return to main menu.
12-6 Automatic Selection Programming