Comdial DXP Plus Series, Руководство пользователя

Страница: 840 / 1176

Ringing Preference (Ringing Line Preference)
Description:
When you enable this feature, a station can automatically connect to a ringing line when a user
takes his or her telephone off-hook. Refer to
Section
7.2. for other ringing considerations.
Programming:
1. Press CONTROL T for main menu.
2. From the main menu, select stations and press ENTER.
3. From the stations menu, select COS programming and press ENTER.
4. Type class of service number (l-32) and press ENTER.
5. From the COS programming menu, type item number for feature and press ENTER.
6. Press SPACE bar for feature setting.
7. When finished, press ESCAPE twice.
8 . Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4-8 for each COS or press ESCAPE to end.
7.1.24
Day Route Access/Night Route Access
Description:
You must use
Section
12.4 to build and assign automatic route selection (ARS) route tables
before the system can perform ARS on a dialed number. Each of the six routes of a route table
require a route access level of 1 to 4. ARS uses this route access level to determine if the
dialing station has access to dial out on the route. It does this by comparing a station’s route
access level to the required dial out access level. If the station route access level is greater than
or equal to the route access level that you assign to the route, the system allows the station to
access the route. Otherwise, the system will not accept the dialed number, and sounds an error
at the station’s speaker or handset. The route access level allows some stations to gain access
to the more costly routes in a route table while denying it to others. Just as you program each
route from least to most costly, you must also arrange the station’s route access level to increase
from a low level to a high level. This is necessary because once the system denies access
because of the access level, it will not try another route. The more costly the route is, the higher
the access level needed to access it.
Use the following programming procedure to assign a route access level of 1 to 4 to a station
class of service for both day and night operation.
Programming:
1. Press CONTROL T for main menu.
2. From the main menu, select stations and press ENTER.
3. From the stations menu, select COS programming and press ENTER.
4. Type class of service number (l-32) and press ENTER.
5. From the COS programming menu, type item number for day route access and press ENTER.
6. Type l-4 for restriction level.
7. Press ENTER for night route access level, and type l-4 for restriction level.
7. When finished, press ESCAPE twice.
8. Type y to accept changes, n to reject them, or r to resume editing and press ENTER.
9. Repeat steps 4-8 for each COS or press ESCAPE to end.
Station Features Programming