Avaya Communication Manager, Руководство администратора, Страница: 81 / 1854

Managing Phones
Installing New Phones
Administrator’s Guide for Avaya Communication Manager 81
November 2003
3
Managing Phones
Installing New Phones
Simple administration allows you to plug a telephone into a jack and dial a sequence to start up service to
the phone. The dialing sequence sets up an association between the phone and the corresponding station
administration.
SECURITY ALERT:
!
If you do not manage this feature carefully, its unauthorized use may cause you security
problems. Consult the Avaya Products Security Handbook for suggestions on how to
secure your system and find out about obtaining additional security information.
For traditional instructions, see Installing New Phones .
Before you start
On the Feature-Related System Parameters screen, be sure the Customer Telephone Activation (CTA)
Enabled field is y and the TTI Enabled field is y.
Complete the Station screen for the new phone and type x in the port field. Note that the phone type must
match the board type. For example, match a two-wire digital phone with a port on a two-wire digital
circuit pack. Use this procedure with all circuit-switched phones except BRI (ISDN) and model 7103A.
Tip:
See Completing the station screens for more information. See Using Templates to Add
Phones if you want to add a number of phones with similar settings.
Instructions
CAUTION:
You can destroy your hardware if you attempt to connect an analog telephone to a digital
port.
To associate a phone with existing x-port station administration, complete the following steps from the
telephone you want to install:
1
Plug the phone into the wall jack.
2
Lift the receiver and continue if you hear dial tone.
3
Dial #*nnnn, where
nnnn
is the extension number of the phone you are installing.
4
Hang up after you receive confirmation tone.