Allied Telesis x510-28GPX, Справочник по командам

Страница: 746 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 746
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
P
OWER OVER
E
THERNET
C
OMMANDS
SHOW POWER
-
INLINE INTERFACE
Related
Commands
show power-inline
show power-inline interface detail
Pri
The current PoE priorities for PoE ports on the PSE, as configured
from a
power-inline priority command:
• Low displays when the
low
parameter is issued. The lowest
priority for a PoE enabled port (default).
• High displays when the
high
parameter is issued. The
second highest priority for a PoE enabled port.
• Crit displays when the
critical
parameter is issued. The
highest priority for a PoE enabled port.
Oper
The current PoE port state when this command was issued:
• Powered displays if there is a PD connected and power is
being supplied.
• Denied displays if supplying power would make the switch
go over the power budget.
• Off displays if the port is not supplying power but has not
been denied power by the switch. This is the default state for
ports that are not connected to a PD.
• Disabled displays if the PoE port is administratively disabled.
• Syncing displays if PoE is still initializing the port when you
issue the command.
• Fault displays if there is a problem with PoE on the port.
• Unknown displays if PoE cannot determine the state of the
port.
Power
The power consumption in milliwatts (mW) for the PoE port
when this command was entered.
Device
The description of the connected PD device if a description has
been added with the
power-inline description command. No
description is shown for PDs not configured with the
power-inline description command.
Class
The class of the connected PD, if power is being supplied to the
PD from the PSE.
See the
PoE Feature Overview and Configuration Guide for
further information about power classes.
Max (mW)
The power in milliwatts (mW) allocated for the PoE port.
Additionally, note the following is displayed per PoE port:
• [U] if the power limit for a port was user configured (with the
power-inline max command).
• [L] if the power limit for a port was supplied by LLDP.
• [C] if the power limit for a port was supplied by the PD class.
Table 3: Parameters in show power-inline interface output (cont.)
Parameter Description