Allied Telesis x510-28GPX, Справочник по командам

Страница: 570 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 570
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
VLAN C
OMMANDS
PORT
-
VLAN
-
FORWARDING
-
PRIORITY
port-vlan-forwarding-priority
Overview Use this command to specify which protocol has the highest priority for controlling
transitions from blocking to forwarding traffic, when more than one of EPSR, Loop
Protection, and MAC thrashing protection are used on the switch.
These protocols use the same mechanism to block or forward traffic. This
command specifies either EPSR or Loop Protection as the highest priority protocol.
Setting the priority stops contention between protocols.
For more information, see the Usage section below.
CAUTION
: The loop-protection and none parameter options must not be set on an
EPSR master node. Use the epsr parameter option on an EPSR master node instead.
Setting this command incorrectly on an EPSR master node could cause unexpected
broadcast storms.
Use the no variant of this command to restore the default highest priority protocol
back to the default of EPSR.
For more information about EPSR, see the EPSR Feature Overview and
Configuration_Guide .
Syntax port-vlan-forwarding-priority {epsr|loop-protection|none}
no port-vlan-forwarding-priority
Default By default, the highest priority protocol is EPSR
Mode Global Configuration
Usage Only one of EPSR, Loop Protection and MAC Thrashing protection usually needs to
be configured on a switch, because they perform similar functions—each prevents
network loops by blocking a selected port for each (loop-containing) VLAN.
However, if more than one of these three features is configured on a switch, you
can use this command to prioritize either EPSR or Loop Protection when their
Parameter Description
epsr
Sets EPSR as the highest priority protocol. Use this parameter on
an EPSR master node to avoid unexpected broadcast storms.
loop-
protection
Sets Loop Protection as the highest priority protocol.
Note that this option must not be set on an EPSR master node.
Use the
epsr parameter option on an EPSR master node to avoid
unexpected broadcast storms.
none
Sets the protocols to have equal priority. This was the previous
behavior before this command was added, and allows protocols
to override each other to set a port to forwarding a VLAN.
Note that this option must not be set on a EPSR master node.
Use the
epsr parameter option on an EPSR master node to avoid
unexpected broadcast storms.