C613-50170-01 Rev B
Command Reference for x510 Series
2183
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
G.8032 E
THERNET
R
ING
P
ROTECTION
S
WITCHING
C
OMMANDS
ENABLE
(G.8032)
enable (G.8032)
Overview
Use this command to change the revertive or non-revertive operation of the
associated G.8032 Ethernet Ring Protection (ERP) instance.
Syntax
enable {revertive|non-revertive}
Default
By default, the mode of operation is revertive.
Mode
G8032 Profile Configuration
Usage
An ERP instance uses a profile which contains timer configurations and
configurations for revertive modes of operation. Once a ring failure has abated, a
G.8032 ring instance will check its mode of operation, and if the mode is revertive,
it will attempt to revert back to where the RPL-Owner controls the blocking of the
ring. Otherwise, it operates in non-revertive mode.
Example
To enable revertive mode for a profile named “prof_1”, use the following
commands:
awplus(config)#
g8032 profile prof_1
awplus(g8032-profile-config)#
enable revertive
Related
Commands
Command
changes
Version 5.4.7-0.1: command added
Parameter
Description
revertive
This allows the ERP instance associated with this profile to operate
in revertive mode.
non-revertive
This allows the ERP instance associated with this profile to operate
in non- revertive mode.
