Allied Telesis x510-28GPX, Справочник по командам

Страница: 2101 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 2101
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
V
IRTUAL
C
HASSIS
S
TACKING
(VCS
TACK
™) C
OMMANDS
STACK VIRTUAL
-
MAC
stack virtual-mac
Overview This command enables the stack virtual MAC address feature. For more
information on this topic, see the
VCStack Feature Overview and Configuration
Guide . With this command set, the value used as the virtual MAC address is
determined by the setting of the command stack virtual-chassis-id .
You must enable stack virtual-mac , in order to minimize data loss if a new stack
member is required to become the VCStack master.
Before enabling the virtual MAC address feature, you should check that the stack’s
virtual-chassis-id is not already used by another stack in the network. Otherwise
the duplicate MAC addresses will cause problems for the network traffic.
Syntax
stack virtual-mac
no stack virtual-mac
Default The stack virtual MAC address feature is disabled by default. However, if you
manually turn on stacking (by entering the
stack enable command), then that
enables the stack virtual MAC address feature as well.
Mode Global Configuration
Usage Note that this command will not take effect until the switch has been rebooted.
Example awplus# configure terminal
awplus(config)# stack virtual-mac
Related
Commands
show running-config
show stack
switch provision (stack)
stack virtual-chassis-id