C613-50170-01 Rev B
Command Reference for x510 Series
741
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
P
OWER
OVER
E
THERNET
C
OMMANDS
SHOW
POWER
-
INLINE
Operational Status
The operational status of the PSU hardware when this
command was issued:
•
On
if the PSU is installed and switched on.
•
Off
when the PSU is switched off (an RPS may be
connected to the switch to power PoE instead of the
PSU).
•
Fault
when there is an issue with the PSU hardware.
Power Usage Threshold
(%)
The configured SNMP trap / log threshold, as configured
from a
command.
Interface
The PoE port(s) in the format portx.y.z, where x is the device
number, y is the module number within the device, and z is
the PoE port number within the module.
Admin
The administrative state of PoE on a PoE port, either
Enabled
or
Disabled
.
Pri
The current PoE priorities for PoE ports, as configured using
the
command:
•
Low
is the lowest priority (this is the default).
•
High
is the second highest priority.
•
Crit
(critical) is the highest priority.
If the switch cannot supply all ports, it will supply critical
ports, then high-priority ports, then low-priority ports.
Oper
The current PoE port state when this command was issued:
•
Powered
displays if there is a PD connected and power
is being supplied.
•
Denied
displays if supplying power would make the
switch go over the power budget.
•
Off
displays if the port is not supplying power but has
not been denied power by the switch. This is the default
state for ports that are not connected to a PD.
•
Disabled
displays if the PoE port is administratively
disabled.
•
Syncing
displays if PoE is still initializing the port when
you issue the command.
•
Fault
displays if there is a problem with PoE on the port.
•
Unknown
displays if PoE cannot determine the state of
the port.
Power
The power consumption in milliwatts (mW) for the PoE
port when this command was entered.
Table 1:
Parameters in the
show power-inline
command output (cont.)
Parameter
Description
