Allied Telesis x510-28GPX, Справочник по командам

Страница: 1562 / 2822

38
C613-50170-01 Rev B Command Reference for x510 Series 1562
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
IPv6 Hardware
Access Control List
(ACL) Commands
Introduction
Overview This chapter provides an alphabetical reference for the IPv6 Hardware Access
Control List (ACL) commands, and contains detailed command information and
command examples about IPv6 hardware ACLs, which are applied directly to
interfaces using the
ipv6 traffic-filter command.
For information about ACLs, see the ACL Feature Overview and Configuration
Guide .
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself. For more information on link aggregation see the following
references:
• Link Aggregation Feature Overview_and Configuration Guide .
• Link Aggregation Commands
Most ACL command titles include usage information in parentheses. When the
command title is completely surrounded by parentheses, the title indicates the
type of ACL filter instead of keywords to enter into the CLI. For example, the title
(named IPv6 hardware ACL: ICMP entry) represents a command with the syntax:
[< sequence-number >] < action > icmp < source-ip > < dest-ip >
[icmp-type < number >] [vlan < 1-4094 >]
Hardware ACLs will permit access unless explicitly denied by an ACL action.
Sub-modes Many of the ACL commands operate from sub-modes that are specific to particular
ACL types. The following table shows the CLI prompts at which ACL commands are
entered.