Allied Telesis x510-28GPX, Справочник по командам

Страница: 1122 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 1122
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
OSPF
V
3
FOR
IP
V
6 C
OMMANDS
IPV
6
OSPF NETWORK
ipv6 ospf network
Overview This command configures the OSPF network type to a type different from the
default for the particular VLAN interface.
The no variant of this command returns the network type to the default for the
particular VLAN interface.
Syntax
ipv6 ospf network [broadcast | non-broadcast | point-to-point |
point-to-multipoint]
no ipv6 ospf network
Default The default is the
broadcast
OSPF network type for a VLAN interface.
Mode Interface Configuration for a VLAN interface.
Usage This command forces the interface network type to the specified type. Depending
on the network type, OSPF changes the behavior of the packet transmission and
the link description in LSAs.
Example The following example shows setting the network type to
point-to-point
on
the VLAN interface
vlan1
:
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ipv6 ospf network point-to-point
Parameter Description
broadcast
Sets the network type to broadcast.
non-broadcast
Sets the network type to NBMA.
point-to-multipoint
Sets the network type to point-to-multipoint.
point-to-point
Sets the network type to point-to-point.