C613-50170-01 Rev B
Command Reference for x510 Series
2202
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
G.8032 E
THERNET
R
ING
P
ROTECTION
S
WITCHING
C
OMMANDS
SHOW
G
8032
ERP
-
INSTANCE
RAPS-Channel VLAN
The VLAN-id that is configured used for sending and
receiving R-APS messages for this ERP instance.
Sub-ring
Specifies whether the ring is operating as a Sub-ring or
otherwise as a Major ring.
Virtual Channel
Specifies whether the sub-ring is operating with a virtual
channel or not.
Data Traffic VLANs
A comma-separated list of configured VLAN-ids
(individually, or range) that are used for data-traffic and
protected by this ERP instance.
TCN To Inst
A comma-separated list of protocols and their instances
that are to be notified when a Topology Change
Notification occurs for this ERP instance. This only applies
to a sub-ring with a Terminating interface and in which
case "-" will be displayed if no target instances have been
identified. Otherwise a "-" is displayed anyway.Identifies
the protocol to notify. Only "G8032" will be supported
initially.<instance-name> - Identifies the instance to notify
for the given protocol.
TCN Flush Event
Specifies if this instance as a target instance is to send out
Flush FDB messages upon TCN notifications by a
detecting instance.Identifies the notifying protocol
allowed. Only "G8032" will be supported initially. If no
protocols have been configured then display "-".
SNMP Traps
Indicates whether SNMP traps have been enabled or
disabled for this ERP instance.
Signal Fail
Indicates whether a Signal Fail condition is being received
over the East or West ring interface. <signal-fail> consists
of:
"-" no Signal Fail is being indicated
"Link" - indicates the interface port or LAG has gone
operationally down.
"CFM MEP <mep-id>" - indicates that a local CFM MEP has
indicated a Signal Fail, and which MEP by mep-id.
Table 1:
Parameters in the output from the
show g8032 erp-instance
command. (cont.)
Parameter
Description
