C613-50170-01 Rev B
Command Reference for x510 Series
1578
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
IP
V
6 H
ARDWARE
A
CCESS
C
ONTROL
L
IST
(ACL) C
OMMANDS
(
NAMED
IP
V
6
HARDWARE
ACL: IP
PROTOCOL
ENTRY
)
Mode
IPv6 Hardware ACL Configuration (accessed by running the command
access-list (named IPv6 hardware ACL)
Default
On an interface controlled by a hardware ACL, any traffic that does not explicitly
match a filter is permitted.
Usage
To use this command, first run the command
and enter the desired access-list name. This changes the prompt to
awplus(config-ipv6-hw-acl)#.
Then use this command (and the other “named IPv6 hardware ACL: entry”
commands) to add filter entries. You can add multiple filter entries to an ACL.
If you specify a sequence number, the new entry is inserted at the specified
location. If you do not specify a sequence number, the switch puts the entry at the
end of the ACL and assigns it the next available multiple of 10 as its sequence
number.
Once you have configured the ACL, use the
command to apply this ACL to a port, VLAN or QoS class-map. Note
that the ACL will only apply to incoming data packets.
54
NARP (NBMA Address Resolution Protocol) [RFC1735]
58
ICMP for IPv6 [RFC1883]
59
No Next Header for IPv6 [RFC1883]
60
Destination Options for IPv6 [RFC1883]
88
EIGRP (Enhanced Interior Gateway Routing Protocol)
89
OSPFIGP [RFC1583]
97
Ethernet-within-IP Encapsulation / RFC3378
98
Encapsulation Header / RFC1241
108
IP Payload Compression Protocol / RFC2393
112
Virtual Router Redundancy Protocol / RFC3768
134
RSVP-E2E-IGNORE / RFC3175
135
Mobility Header / RFC3775
136
UDPLite / RFC3828
137
MPLS-in-IP / RFC4023
138
MANET Protocols / RFC-ietf-manet-iana-07.txt
139-252
Unassigned / IANA
253
Use for experimentation and testing / RFC3692
254
Use for experimentation and testing / RFC3692
255
Reserved / IANA
Table 38-3: IP protocol number and description (cont.)
Protocol Number
Protocol Description [RFC]
