Allied Telesis x510-28GPX, Справочник по командам

Страница: 609 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 609
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
VLAN C
OMMANDS
VLAN
vlan
Overview This command creates VLANs, assigns names to them, and enables or disables
them. Disabling the VLAN causes all forwarding over the specified VLAN ID to
cease. Enabling the VLAN allows forwarding of frames on the specified VLAN.
The no variant of this command destroys the specified VLANs or returns their MTU
to the default.
Syntax vlan < vid> [name <vlan-name> ] [state {enable|disable}]
vlan <vid-range> [state {enable|disable}]
vlan {< vid >| <vlan-name >} [mtu < mtu-value >]
no vlan {< vid > |<vid-range> } [mtu]
Default By default, VLANs are enabled when they are created.
Mode VLAN Configuration
Examples To enable vlan 45, use the commands:
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan 45 name accounts state enable
To destroy vlan 45, use the commands:
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# no vlan 45
Related
Commands
mtu
vlan database
show vlan
Parameter Description
< vid >
The VID of the VLAN to enable or disable, in the range 1-4094.
< vlan-name >
The ASCII name of the VLAN. Maximum length: 32 characters.
< vid-range >
Specifies a range of VLAN identifiers.
< mtu-value >
Specifies the Maximum Transmission Unit (MTU) size in bytes, in the
range 68 to 1500 bytes, for the VLAN.
enable
Puts the VLAN into an enabled state.
disable
Puts the VLAN into a disabled state.