Allied Telesis x510-28GPX, Справочник по командам

Страница: 526 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 526
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
S
WITCHING
C
OMMANDS
MAC ADDRESS
-
TABLE LOGGING
mac address-table logging
Overview Use this command to create log entries when the content of the FDB (forwarding
database) changes. Log messages are produced when a MAC address is added to
or removed from the FDB.
CAUTION
: MAC address table logging may impact the performance of the switch. Only
enable it when necessary as a debug tool.
Use the no variant of this command to stop creating log entries when the content
of the FDB changes.
Syntax
mac address-table logging
no mac address-table logging
Default MAC address table logging is disabled by default.
Mode User Exec/Privileged Exec
Usage When MAC address table logging is enabled, the switch produces the following
messages:
Note that rapid changes may not be logged. For example, if an entry is added and
then removed within a few seconds, those actions may not be logged.
To see whether MAC address table logging is enabled, use the command show
running-config .
Example To create log messages when the content of the FDB changes, use the command:
awplus# mac address-table logging
Related
Commands
show running-config
Change Message format Example
MAC added MAC add < mac > < port > < vlan > MAC add eccd.6db5.68a7 port1.0.1 vlan2
MAC removed MAC remove < mac > < port > < vlan > MAC remove eccd.6db5.68a7 port1.0.1 vlan2