Allied Telesis x510-28GPX, Справочник по командам

Страница: 949 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 949
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
RIP
NG FOR
IP
V
6 C
OMMANDS
DEFAULT
-
METRIC
(IP
V
6 RIP
NG
)
default-metric (IPv6 RIPng)
Overview Use this command to specify the metrics to be assigned to redistributed RIPng
routes.
Use the no variant of this command to reset the RIPng metric back to its default (1).
Syntax default-metric < 1-16 >
no default-metric [< 1-16 >]
Default By default, the RIPng metric value is set to 1.
Mode Router Configuration
Usage This command is used with the redistribute (IPv6 RIPng) command to make the
routing protocol use the specified metric value for all redistributed RIPng routes,
regardless of the original protocol that the route has been redistributed from.
Note, this metric is not applied to routes that are brought into RIPng by using the
route command in router IPv6 RIP configuration mode. This metric is, though,
applied to any RIPng aggregate routes that have been brought into the RIPng
database due to the presence of a component route that was redistributed into
RIPng.
Also note that the default-metric is applied to routes redistributed into RIPng with
no metric assignment in the routemap associated with redistribution.
Example
awplus# configure terminal
awplus(config)# router ipv6 rip
awplus(config-router)# default-metric 8
Related
Commands
ipv6 rip metric-offset
redistribute (IPv6 RIPng)
Parameter Description
<1-16>
Metric value.