Allied Telesis x510-28GPX, Справочник по командам

Страница: 725 / 2822

19
C613-50170-01 Rev B Command Reference for x510 Series 725
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Power over
Ethernet
Commands
Introduction
Overview This chapter contains an alphabetical list of commands used to configure Power
over Ethernet (PoE). Each command contains a functional description and shows
examples of configuration and output screens for show commands. These
commands are only supported on PoE capable ports. An error message will display
on the console if you enter a PoE command on a port that does not support PoE.
The following documents offer further information for configuring PoE on
AlliedWare Plus switches.
• the PoE Feature Overview and Configuration_Guide .
• the Support for Allied Telesis Enterprise_MIBs_in AlliedWare Plus , for
information about which PoE MIB objects are supported.
• the SNMP Feature Overview and Configuration_Guide , for information about
SNMP traps.
Power over Ethernet (PoE) is a technology allowing devices such as security
cameras to receive power over LAN cabling.
The Powered Device (PD) referred to throughout this chapter is a PoE or PoE+
powered device, such as an IP phone or a Wireless Access Point (WAP).
Command List • “ clear power-inline counters interface ” on page 727
• “ debug power-inline ” on page 728
• “ power-inline allow-legacy ” on page 730
• “ power-inline description ” on page 731
• “ power-inline enable ” on page 732
• “ power-inline max ” on page 733
• “ power-inline priority ” on page 735
• “ power-inline usage-threshold ” on page 737
• “ service power-inline ” on page 738