C613-50170-01 Rev B
Command Reference for x510 Series
733
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
P
OWER
OVER
E
THERNET
C
OMMANDS
POWER
-
INLINE
MAX
power-inline max
Overview
This command sets the maximum power allocated to a Power over an Ethernet
(PoE and PoE+) port. The amount of power actually supplied to the port depends
on the power requirements of the connected PD. It is also a function of the total
PoE power loading on the switch and the PoE priority set for the port by the
command. However this command (power-inline max) does
apply a maximum value to the power that the port is able to supply.
Note that the value set by this command will be the figure the switch will use when
apportioning the power budget for its ports. For example, if 15.4 W is assigned to
a port whose PD only consumes 5 W, the switch will reserve the full 15.4 W for this
port when determining its total power PoE power requirement.
The
no
variant of this command sets the maximum power supplied to a PoE port
to the default, which is set to the maximum power limit for the class of the
connected Powered Device (PD).
Syntax
power-inline max <
4000-30000
>
no power-inline max
Default
The switch supplies the maximum power limit for the class of the PD connected to
the port by default.
NOTE
:
See the
PoE Feature Overview and Configuration Guide
for further information
about power classes.
Mode
Interface Configuration for one or more ports. If you specify a range or list of ports,
they must all be PoE capable ports.
Usage
If you select a range of PoE ports in Interface Configuration mode before issuing
this command, then each port in the range selected will have the same maximum
power value configured. If the PoE port attempts to draw more than the maximum
power, this is logged and all power is removed.
Note that the value entered is rounded up to the next value supported by the
hardware. The actual value used is displayed after you enter the command, such as
in the following sample console output:
Parameter
Description
<
4000-30000
>
The maximum power supplied to a PoE port in milliwatts
(mW).
