C613-50170-01 Rev B
Command Reference for x510 Series
2099
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
V
IRTUAL
C
HASSIS
S
TACKING
(VCS
TACK
™) C
OMMANDS
STACK
SOFTWARE
-
AUTO
-
SYNCHRONIZE
stack software-auto-synchronize
Overview
This command re-enables the software version auto-synchronization feature
either on a specified stack member or all stack members.
Use the
no
variant of this command to turn the software version auto
synchronization feature off.
Syntax
stack {all|<
stack-ID
>} software-auto-synchronize
no stack {all|<
stack-ID
>} software-auto-synchronize
Default
All the stack members have the stack software-auto-synchronize feature enabled
by default.
Mode
Global Configuration
Usage
This command is used to enable the software version auto-synchronization feature
for either a specific stack member or all stack members and candidates.
Note that if a device attempts to join a stack but is running a software release that
is different to the other stack members, the software version auto-synchronization
feature will copy the master's software release onto the new member. If the
software version auto-synchronization feature is not enabled, then the device will
be unable to join the stack.
Note that the software version auto-synchronization feature may also result in the
stack member downgrading its software release if the master is running an older
software version.
Examples
To turn on the software-auto-synchronize feature on stack member 2, which was
previously turned off, use the following commands:
awplus#
configure terminal
awplus(config#
stack 2 software-auto-synchronize
To turn on the software-auto-synchronize feature for all stack members, which
were previously turned off, use the following commands:
awplus#
configure terminal
awplus(config)#
stack all software-auto-synchronize
Related
Commands
Parameter
Description
all
All stack members.
<
stack-ID
>
Stack member number, from 1 to 8.
