Allied Telesis x510-28GPX, Справочник по командам

Страница: 556 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 556
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
S
WITCHING
C
OMMANDS
SPEED
speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the show
interface command. To see the configured speed (when different from the
default), use the show running-config command.
Syntax
speed {10|100|1000|10000}
speed auto [10] [100] [1000] [10000]
The following table shows the speed options for each type of port.
Mode Interface Configuration
Default By default, ports autonegotiate speed (except for 100Base-FX ports which do not
support auto-negotiation, so default to 100Mbps).
Usage Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
NOTE
: If multiple speeds are specified after the auto option to autonegotiate speeds,
then the device only attempts autonegotiation at those specified speeds.
Examples To set an SFP to a fixed speed of 1000Mbps, enter the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.49
awplus(config-if)# speed 1000
Port type Speed Options (units are Mbps)
RJ-45 copper ports
auto
(default)
10
100
1000
tri-speed copper SFPs
auto
(default)
10
100
1000
100Mbps fiber SFPs
100
1000Mbps copper or fiber SFPs
auto
(default)
1000
10000Mbps fiber SFP+
auto
(default)
10000