R&S 1129.7246.03, Operating Manual

Page: 566 / 855

Operating Manual 1302.6163.12 - 03 6.127
R&S ESU Remote Control – Description of Commands
INITiate Subsystem
This command is an event and therefore has no *RST value and no query.
INITiate<1|2>:DISPlay ON | OFF
This command configures the behavior of the display during a single sweep.
The numeric suffix of INITiate is irrelevant with this command.
Parameter: OFF: the display is switched off during the measurement,
ON: the display is switched on during the measurement.
Example:
"INIT2:CONT OFF"
'Switches to single-sweep mode
"INIT2:DISP OFF"
'Sets the display behavior to
OFF
"INIT2;*WAI"
'Starts the measurement with display switched off.
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
INITiate<1|2>:ESPectrum
This command starts a Spectrum Emission Mask measurement. The measurement can be stopped in
continuous sweep mode with
ABORt .
Example:
"SENS:SWE:MODE ESP"
' activates the SEM measurement
"INIT:CONT OFF"
' Set to Single Sweep
"INIT:ESP"
' Starts a SEM measurement
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
INITiate<1|2>:FMEasurement
In receiver mode, this command starts the final measurement based on the peak list.
Example:
"INIT2:FME"
'Starts the final measurement
Characteristics: *RST value: -
SCPI: device-specific
Mode: R
This command is an event, so it has neither an *RST value nor a query function.