RMON Rising and Falling Trap Events
EPICenter Reference Guide
535
RMON Rising and Falling Trap Events
An RMON rising trap indicates that the value of the monitored variable has risen to or above the rising
threshold value. RMON rules need to be configured on a device for it to send out this trap. See
“Threshold Configuration” on page 127
” for more information.
An RMON falling trap indicates that the value of the monitored variable has fallen to or below the
falling threshold value. RMON rules need to be configured on a device for it to send out this trap. See
“Threshold Configuration” on page 127
” for more information.
EPICenter Events
An EPICenter event is generated by the EPICenter server based on the results of its periodic polling. In
some cases, an EPICenter event may result from the same condition that could generate an SNMP or
other trap. An EPICenter event has the advantage that it guarantees that the condition will be detected
(by polling) even if the corresponding trap is missed.
OSPF Virtual Interface State Change
set ospfSetTrap bit 1 ON
OSPF Neighbor State Change
set ospfSetTrap bit 2 ON
OSPF Virtual Neighbor State Change
set ospfSetTrap bit 3 ON
OSPF Interface Config Error
set ospfSetTrap bit 4 ON
OSPF Virtual Interface Config Error
set ospfSetTrap bit 5 ON
OSPF Interface Authentication Failure
set ospfSetTrap bit 6 ON
OSPF Virtual Interface Authentication
Failure
set ospfSetTrap bit 7 ON
OSPF Interface Receive Bad Packet
set ospfSetTrap bit 8 ON
OSPF Virtual Interface Receive Bad Packet
set ospfSetTrap bit 9 ON
OSPF TX_Retransmit
set ospfSetTrap bit 10 ON
OSPF Virtual Interface TX Retransmit
set ospfSetTrap bit 11 ON
OSPF Originate LSA
set ospfSetTrap bit 12 ON
OSPF Max_Age LSA
set ospfSetTrap bit 13 ON
OSPF LSDB Overflow
set ospfSetTrap bit 14 ON
OSPF LSDB Approaching Overflow
set ospfSetTrap bit 15 ON
OSPF Interface State Change
set ospfSetTrap bit 16 ON
Table 60: EPICenter Events, Detected Through Polling
Event
Definition
Configuration Upload Failed
The EPICenter server generates this event when it fails to upload
configuration information from a device. This event occurs ONLY when the
upload is attempted from EPICenter, not if it was attempted from Telnet,
ExtremeWare Vista or any other method.
Table 59: Trap Variable Configuration
Trap
Variables
Summary of Contents for EPICenter 6.0
