Extreme Networks EPICenter 6.0, Reference Manual

Page: 502 / 580

Using the Policy Manager
EPICenter Reference Guide
502
Resetting a Policy
Use the Reset policy button to undo the changes you have made to a policy definition at any time
before you save it . The reset operation returns the settings of the policy to the last saved settings for the
policy. In the case of a new policy, it will remove all policy settings.
Configuring Policy Precedence
To configure the precedence settings of your policies, click the Order Policy Precedence button
to display the Order Policy Precedence window as shown in Figure 263 .
Figure 263: Order Policy Precedence window
Policies are displayed in the Configure Policy Precedence window in their current precedence order,
from highest at the top to lowest at the bottom. The top entry in the list has the highest priority, the last
entry has the lowest priority. In the case where multiple policies could apply to the same traffic flow,
the policy with higher priority is used by the switch over policies of lower priority.
The policy precedence defined in this window only controls the relationships between policies of the
same type. Policies of different types have a predefined precedence relationship: Security and IP QoS
policies are the highest priority, Source Port QoS policies are second, and VLAN QoS policies have the
lowest priority. For Security and IP policies, the precedence can be manipulated between the two types
since they are of similar type in this respect. For VLAN and source port policies, you can only
manipulate its precedence relative to other policies of the same type.
If all other precedence variables are equal, and you do not change the precedence order explicitly, then
precedence is determined by the time of creation, with the policy created last having the lowest
precedence, and will appear at the bottom of the list.
●
To change the precedence of a policy, select the policy, and click the appropriate Up or Down arrow
button to move the policy higher or lower in the list. Move a policy up in the list to give it priority
over the policies below it in the list. Move it lower in the to reduce its priority relative to other
policies.