Extreme Networks EPICenter 6.0, Reference Manual

Page: 425 / 580

Wireless Reports
EPICenter Reference Guide
425
Remote connect (virtual) interfaces are indicated by a “v” preceding the interface identifier. For each
wireless interface, it shows the following:
Safe AP MAC List
The Safe AP MAC List shows the list of MAC addresses that belong to Access Points that have been
determined to be legitimate and added to this list. If you are an Administrator (with the Administrator
role) you can also manage the list of safe MAC addresses through this page, by importing lists of MAC
addresses or deleting the list.
You can add individual MAC addresses to this list through the Rogue Access Point Detail Report.
Figure 217 shows an example of this report.
Port State • Disabled : Wireless port is disabled
• Enabled : Wireless port is enabled
• Online : Wireless port is connected, enabled, and functioning correctly
• Error : Wireless port is connected but is not functioning correctly
State Change Time at which port last changed state
Location Location information for the AP connected to this port
Description Description of the AP
SSID Service set ID for the wireless interface
MAC Address MAC address of the wireless interface (radio)
RF Mode Wireless LAN RF mode: 802.11a, 802.11b, 802.11g, or 802.11b/g
Channel Radio frequency channel used by the interface
RF Profile RF profile used by the interface
Bridging Whether bridging is enabled (Yes or No)
Interface State Enabled or Disabled
State Change Time at which interface last changed state
Network Auth Network Authorization method configured for this interface
Dot11 Auth Authentication method: (open for no WEP, or shared for shared key WEP authentication)
Encryption Length Encryption length (64 or 128 for WEP, 0 for no WEP))
Encryption Encryption method (none, WEP64, TKIP, WRAP, CCMP, WEP128, Other)
Security Profile Security profile used by the interface
Client Data VLAN VLAN to use for client data if VLAN is not received as a RADIUS Vendor Specific
Attribute (VSA)
Data VLAN Tag Tag of the client data VLAN
Use VSA VLAN If True, use the VSA VLAN returned by the RADIUS server. If False, ignore the VSA
VLAN returned.