Delta ASD-B2-0121-B, User Manual

Page: 88 / 313

Revision June 2010
5-1
Chapter 5 Trial Run and Tuning Procedure
This chapter, which is divided into two parts, describes trial run for servo drive and motor.
One part is to introduce the trial run without load, and the other part is to introduce trial run
with load. Ensure to complete the trial run without load first before performing the trial run
with load.
5.1 Inspection without Load
In order to prevent accidents and avoid damaging the servo drive and mechanical system, the
trial run should be performed under no load condition (no load connected, including
disconnecting all couplings and belts). Do not run servo motor while it is connected to load or
mechanical system because the unassembled parts on motor shaft may easily disassemble
during running and it may damage mechanical system or even result in personnel injury. After
removing the load or mechanical system from the servo motor, if the servo motor can runs
normally following up the normal operation procedure (when trial run without load is
completed), then the users can connect to the load and mechanical system to run the servo
motor.
¾
In order to prevent accidents, the initial trial run for servo motor should be conducted
under no load conditions (separate the motor from its couplings and belts).
¾
Caution: Please perform trial run without load first and then perform trial run with load
connected. After the servo motor is running normally and regularly without load, then
run servo motor with load connected. Ensure to perform trial run in this order to prevent
unnecessary danger.