Delta ASD-B2-0121-B, User Manual

Page: 121 / 313

Chapter 6 Control Modes of Operation
6-12
Revision June 2010
A/D
P1-09
~P1-11
P1-40
S-curve filter
P1-34,
P1-35,
P1-36
P1-01
P1-06
Analog command
filter
P1-34,
P1-35,
P1-36
SPD0,SPD1 signal of CN1
Analog signal
Command
selection
Low-pass
filter
(Command source:
Internal parameter)
(Command source:
External analog signal)
Internal
parameter
Proportion
Gain
The command source is selected according to the state of SPD0, SPD1 and parameter P1-
01 (S or Sz). Whenever the command signal needs to be more smoothly, we recommend
the users to use S-curve and low-pass filter.
6.3.3 Smoothing Strategy of Speed Control Mode
S-curve Filter
The S-curve filter is a speed smoothing command which provides 3 steps accel / decel S-
curve to smooth the speed command change of the motor during acceleration and
deceleration. Using S-curve filter can let the servo motor run more smoothly in response
to a sudden speed command change. Since the speed and acceleration curve are both
continuous, in order to avoid the mechanical resonance and noise may occur due to a
sudden speed command (differentiation of acceleration), using S-curve filter not only can
improve the performance when servo motor accelerate or decelerate but also can make
the motor run more smoothly. S-curve filter parameters include P1-34 Acceleration Time
(TACC), P1-35 Deceleration Time (TDEC) and Accel /Decel S-curve (TSL), and the users can
use these three parameters to improve the motor performance during acceleration,
deceleration and operation. ASDA-B2 series servo drives also support the time calculation
of completing speed command. T (ms) is the operation (running) time. S (r/min) is
absolute speed command, i.e. the absolute value (the result) after starting speed
subtracts the final speed.