Atmel SAM4S Series, Preliminary Data Sheet

Page: 993 / 1163

993
11100B–ATARM–31-Jul-12
SAM4S Series [Preliminary]
38.6.2.5 Transmit Data Cancellation
Some endpoints have dual-banks whereas some endpoints have only one bank. The procedure
to cancel transmission data held in these banks is described below.
To see the organization of dual-bank availability refer to Table 38-1 ”USB Endpoint Description” .
Endpoints Without Dual-Banks
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
• TXPKTRDY is not set:
– Reset the endpoint to clear the FIFO (pointers). (See, Section 38.7.9 ”UDP Reset
Endpoint Register” .)
• TXPKTRDY has already been set:
– Clear TXPKTRDY so that no packet is ready to be sent
– Reset the endpoint to clear the FIFO (pointers). (See, Section 38.7.9 ”UDP Reset
Endpoint Register” .)
Endpoints With Dual-Banks
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
• TXPKTRDY is not set:
– Reset the endpoint to clear the FIFO (pointers). (See, Section 38.7.9 ”UDP Reset
Endpoint Register” .)
• TXPKTRDY has already been set:
– Clear TXPKTRDY and read it back until actually read at 0.
– Set TXPKTRDY and read it back until actually read at 1.
– Clear TXPKTRDY so that no packet is ready to be sent.
– Reset the endpoint to clear the FIFO (pointers). (See, Section 38.7.9 ”UDP Reset
Endpoint Register” .)