Atmel SAM4S Series, Preliminary Data Sheet

Page: 595 / 1163

595
11100B–ATARM–31-Jul-12
SAM4S Series [Preliminary]
Figure 30-7. Receiver Clock Management
30.7.1.4 Serial Clock Ratio Considerations
The Transmitter and the Receiver can be programmed to operate with the clock signals provided
on either the TK or RK pins. This allows the SSC to support many slave-mode data transfers. In
this case, the maximum clock speed allowed on the RK pin is:
– Master Clock divided by 2 if Receiver Frame Synchro is input
– Master Clock divided by 3 if Receiver Frame Synchro is output
In addition, the maximum clock speed allowed on the TK pin is:
– Master Clock divided by 6 if Transmit Frame Synchro is input
– Master Clock divided by 2 if Transmit Frame Synchro is output
30.7.2 Transmitter Operations
A transmitted frame is triggered by a start event and can be followed by synchronization data
before data transmission.
The start event is configured by setting the Transmit Clock Mode Register (SSC_TCMR). See
“Start” on page 597.
The frame synchronization is configured setting the Transmit Frame Mode Register
(SSC_TFMR).
See “Frame Sync” on page 599.
To transmit data, the transmitter uses a shift register clocked by the transmitter clock signal and
the start mode selected in the SSC_TCMR. Data is written by the application to the SSC_THR
register then transferred to the shift register according to the data format selected.
When both the SSC_THR and the transmit shift register are empty, the status flag TXEMPTY is
set in SSC_SR. When the Transmit Holding register is transferred in the Transmit shift register,
the status flag TXRDY is set in SSC_SR and additional data can be loaded in the holding
register.
RK (pin)
Transmitter
Clock
Divider
Clock
CKS
CKO
Data Transfer
CKI
CKG
Receiver
Clock
Clock
Output
MUX
Tri-state
Controller
Tri-state
Controller
INV
MUX