Atmel SAM4S Series, Preliminary Data Sheet

Page: 352 / 1163

352
11100B–ATARM–31-Jul-12
SAM4S Series [Preliminary]
In the same way, the Clear Lock command (CLB) is used to clear lock bits.
Lock bits can be read using the Get Lock Bit command (GLB). The n
th
lock bit is active when the
bit n of the bit mask is set..
20.2.5.5 Flash General-purpose NVM Commands
General-purpose NVM bits (GP NVM bits) can be set using the Set GPNVM command (SGPB).
This command also activates GP NVM bits. A bit mask is provided as argument to the com-
mand. When bit 0 of the bit mask is set, then the first GP NVM bit is activated.
In the same way, the Clear GPNVM command (CGPB) is used to clear general-purpose NVM
bits. The general-purpose NVM bit is deactivated when the corresponding bit in the pattern value
is set to 1.
General-purpose NVM bits can be read using the Get GPNVM Bit command (GGPB). The n
th
GP NVM bit is active when bit n of the bit mask is set..
20.2.5.6 Flash Security Bit Command
A security bit can be set using the Set Security Bit command (SSE). Once the security bit is
active, the Fast Flash programming is disabled. No other command can be run. An event on the
Erase pin can erase the security bit once the contents of the Flash have been erased.
Table 20-9. Set and Clear Lock Bit Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE SLB or CLB
2 Write handshaking DATA Bit Mask
Table 20-10. Get Lock Bit Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE GLB
2 Read handshaking DATA
Lock Bit Mask Status
0 = Lock bit is cleared
1 = Lock bit is set
Table 20-11. Set/Clear GP NVM Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE SGPB or CGPB
2 Write handshaking DATA GP NVM bit pattern value
Table 20-12. Get GP NVM Bit Command
Step Handshake Sequence MODE[3:0] DATA[15:0]
1 Write handshaking CMDE GGPB
2 Read handshaking DATA
GP NVM Bit Mask Status
0 = GP NVM bit is cleared
1 = GP NVM bit is set