Atmel SAM4S Series, Preliminary Data Sheet

Page: 986 / 1163

986
11100B–ATARM–31-Jul-12
SAM4S Series [Preliminary]
Figure 38-6. Setup Transaction Followed by a Data OUT Transaction
38.6.2.2 Data IN Transaction
Data IN transactions are used in control, isochronous, bulk and interrupt transfers and conduct
the transfer of data from the device to the host. Data IN transactions in isochronous transfer
must be done using endpoints with ping-pong attributes.
Using Endpoints Without Ping-pong Attributes
To perform a Data IN transaction using a non ping-pong endpoint:
1. The application checks if it is possible to write in the FIFO by polling TXPKTRDY in the
endpoint’s UDP_CSRx register (TXPKTRDY must be cleared).
2. The application writes the first packet of data to be sent in the endpoint’s FIFO, writing
zero or more byte values in the endpoint’s UDP_FDRx register,
3. The application notifies the USB peripheral it has finished by setting the TXPKTRDY in
the endpoint’s UDP_CSRx register.
4. The application is notified that the endpoint’s FIFO has been released by the USB
device when TXCOMP in the endpoint’s UDP_CSRx register has been set. Then an
interrupt for the corresponding endpoint is pending while TXCOMP is set.
5. The microcontroller writes the second packet of data to be sent in the endpoint’s FIFO,
writing zero or more byte values in the endpoint’s UDP_FDRx register,
6. The microcontroller notifies the USB peripheral it has finished by setting the TXPK-
TRDY in the endpoint’s UDP_CSRx register.
7. The application clears the TXCOMP in the endpoint’s UDP_CSRx.
After the last packet has been sent, the application must clear TXCOMP once this has been set.
TXCOMP is set by the USB device when it has received an ACK PID signal for the Data IN
packet. An interrupt is pending while TXCOMP is set.
Warning: TX_COMP must be cleared after TX_PKTRDY has been set.
Note: Refer to Chapter 8 of the Universal Serial Bus Specification, Rev 2.0, for more information on the
Data IN protocol layer.
RX_Data_BKO
(UDP_CSRx)
ACK
PID
Data OUT
Data OUT
PID NAK
PID ACK
PID
Data Setup
Setup
PID USB
Bus Packets
RXSETUP Flag
Set by USB Device Cleared by Firmware
Set by USB
Device Peripheral
FIFO (DPR)
Content
Data Setup Data XX XX OUT
Interrupt Pending
Setup Received Setup Handled by Firmware Data Out Received
Data OUT
Data OUT
PID