![background image](http://html1.mh-extra.com/html/abbott/cell-dyn-3200/cell-dyn-3200_system-operators-manual_450985088.webp)
2-12
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Installation Procedures and Special Requirements
Printer Installation
Section 2
Figure 2.7 CELL-DYN 3200 Printer Ports
Graphics Printer Installation Procedure
1. Assemble the printer as directed in the printer manual.
2. Make sure that the printer power switch is OFF. Plug the power cord into the
printer. Do not plug the other end into an outlet until you are ready to load
paper.
3. Make sure that the power to the instrument is turned OFF. Remove the printer
cable (which looks like a power cord with two connectors) from the
Accessory kit and plug one end into the parallel port on the rear of the printer.
(There is a metal plate covering the printer’s serial port to avoid confusion.)
Fasten the wire clips to the connector for a secure connection.
4. Plug the other end of the printer cable into the Graphics Printer port on the
back of the Data Module. (See Figure 2.7) Tighten the screws on the
connector for a secure connection.
NOTE:
This port is configured for use as a graphics printer only. To print
tickets, you may connect a Ticket Printer to the Ticket Printer port.
5. Install the ink cartridge as directed in the printer manual.
6. Load the paper as directed in the printer manual.
7. If necessary, refer to
Section 5: Operating Instructions
for instructions on customizing the printout.
1 Graphics Printer Port
2 Ticket Printer Port
1
2