5-70
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Operating Instructions
Run Menu
Section 5
Figure 5.30 Work List Screen - Page 2
The Work List is used to pre-assign sample identification, display and print criteria
for samples that will be run. It is essentially a list of samples (including the pre-
assigned information) that the operator intends to run on the instrument.
The Work List may be used with or without bar code labels on the tubes. However,
if bar codes are used on the tubes, they must contain more than two digits to avoid
a possible mis-reading of the 2-digit bar code assigned to each rack.
For a detailed discussion of the Work List, refer to
Using the Work List
later in this
section.
