ABB Relion 670 series, Technical Manual

Page: 1204 / 1432

18.10.4 Operation principle
GUID-950F2501-9183-43C0-A193-7D15124F6CCE v2
The DVALIDx output will be HIGH if the incoming message is with valid data.
The COMMVALID output will become LOW when the sending IED is under total failure condition
and the GOOSE transmission from the sending IED does not happen.
The TEST output will go HIGH if the sending IED is in test mode.
Data Value Data Valid Comm Valid Test
Incoming data with q=Normal Updated 1 1 0
Incoming data with q=oldData 1 0 1 0
Incoming data with q=Invalid 0 0 1 0
Incoming data with q=test 0 0 1 1
Incoming data with q=test+oldData 0 0 1 1
Receiver in block 0 0 1 0
Receiver in block and communication
error
0 0 0 0
Receiver in test mode and incoming data
with q= Normal
Updated 1 1 0
Receiver in test mode and incoming data
with q= Test
Updated 1 1 1
Communication Error 0 0 0 0
At least one of the inputs of this GOOSE block must be linked either in SMT by
means of a cross or in ACT by means of a GOOSE connection (if easy GOOSE
engineering is enabled) to receive any data. Only those outputs whose source input
is linked/connected will be updated.
The implementation for IEC 61850 quality data handling is restricted to a simple
level. If quality data validity is GOOD then the DVALIDx output will be HIGH. If
quality data validity is INVALID, QUESTIONABLE, OVERFLOW, FAILURE or OLD DATA
then the DVALIDx output will be LOW.
18.11 GOOSE function block to receive a double point value
GOOSEDPRCV
18.11.1 Identification
GUID-8C11DB9A-7844-4E1F-A6BB-D97ECE350FC1 v1
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
GOOSE function block to receive a
double point value
GOOSEDPRCV - -
Section 18 1MRK 502 066-UUS B
Station communication
1198
Technical manual