Sirona ORTHOPHOS XG 3 DS, Руководство по обслуживанию

Страница: 501 / 578

båÖäáëÜ
59 38 399 D3352
D3352.076.01.13.02
07.2008
6 – 69
Tab 6 6.20 Replacing circuit boards
6.20
16. Determine the ring type based on the system serial number.
PAN unit serial numbers up to 20056 = old ring type = 01
PAN unit serial numbers from 20057 = new ring type = 02
PAN/CEPH unit serial numbers up to 40104 = old ring type = 01
PAN/CEPH unit serial numbers from 40105 = new ring type = 02
17. Start service routine S034.7 and select the corresponding ring type (see
page 5-145).
18. Start service routine S017 and perform the system configuration (test
step 2-17) (see page 5-78).
NOTE
i
For systems with hardware version< BA (until October 2006):
– Circuit board DX41 must be configured with service routine S017.9.
– Review the installed headrest version and adjust the configuration, using
service routine S017.10 if necessary (see page 5.13.8).
NOTE
i
Inform the customer about the new possibilities of the software status, such as
welcome screen (XG
Plus
only) or acoustic exposure signal. Activate these
functions if they are required.
19. If the minimum travel height of the system must be limited:
Set the travel height with service routine
S018.2 . (see page 5-110).
20. Perform another software update to the current system software version
as described in section 1.9.3. This updates all modules in accordance
with the configuration.
21. Perform the complete system adjustment (see chapter 4):
– PAN adjustment
– For TSA units: TSA adjustment
– CEPH adjustment if cephalometer is installed
22. Open the "Extended Details“ via SIXABCON.
This generates an XML file (with the system parameters) which is saved
under the network name of the system in the PDATA/P2K_Config folder
(see also section 1.10 on page 1-32).
z
The process is completed.