Mitsubishi Electric MELSERVO-J2-Super Series, Руководство по переходу

Страница: 310 / 662

Part 7: Common Reference Material
7 - 71
MR-J2S-_CP_ MR-J4-_A_-RJ
Conversion rule
No. Name Type Target No. Type Target
79 For manufacturer setting Hex _ _ XX PD22 Hex XX _ _
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 2B _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
80 For manufacturer setting Hex
_ _ XX PD12 Hex XX _ _
However, a setting value other than those in
Table 1 will be converted to 38 _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
XX _ _ PD06 Hex XX _ _
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 20 _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
81 For manufacturer setting Hex
_ _ XX PD08 Hex XX _ _
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 07 _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
XX _ _ PD10 Hex XX _ _
The setting value will be converted as shown in
Table 1 (as input).
However, a setting value other than those in
Table 1 will be converted to 08 _ _.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
Hex: hexadecimal parameter; Dec: decimal parameter